我正在嘗試使用 python 將 cisco 運行配置轉換為參數(shù)，但我一直堅持使用 python 讀取配置部分。例如，假設您有以下節(jié)：!interface Async1 no ip address encapsulation slip!       router bgp 65500 bgp router-id 1.1.1.1 bgp log-neighbor-changes timers bgp 10 30 neighbor 1.2.3.4 remote-as 1234 neighbor 1.2.3.4 description Some Description neighbor 1.2.3.4 update-source GigabitEthernet0/0 ! address-family ipv4  network 2.2.2.2 mask 255.255.255.255  network 3.3.3.0 mask 255.255.255.252  neighbor 1.2.3.4 activate  neighbor 1.2.3.4 allowas-in 3  neighbor 1.2.3.4 prefix-list PXL out exit-address-family!ip forward-protocol ndno ip http serverno ip http secure-server!我想從“路由器 bgp”中讀取行，直到第一行以“！”開頭 （例如^?。?，然后重新讀取塊以將參數(shù)提取到變量中。示例輸出將是：router bgp 65500 bgp router-id 1.1.1.1 bgp log-neighbor-changes timers bgp 10 30 neighbor 1.2.3.4 remote-as 1234 neighbor 1.2.3.4 description Some Description neighbor 1.2.3.4 update-source GigabitEthernet0/0 ! address-family ipv4  network 2.2.2.2 mask 255.255.255.255  network 3.3.3.0 mask 255.255.255.252  neighbor 1.2.3.4 activate  neighbor 1.2.3.4 allowas-in 3  neighbor 1.2.3.4 prefix-list PXL out exit-address-family!注意：我可以使用 awk 或 grep 提取上述代碼，但我想將我的 bash 代碼轉換為 Python。謝謝！